Figure 41: Seating the OSFP Transceiver Module
Caution
If the latch isn’t fully engaged, you might accidentally disconnect the transceiver module.
Attach the Optical Network Cable
Before you begin
Before you remove the dust plugs and make any optical connections, follow these guidelines:
• Keep the protective dust plugs installed in the unplugged fiber-optic cable connectors and in the transceiver
optical bores until you are ready to make a connection.
• Inspect and clean the optical connector end faces just before you make any connections.
• Grasp the optical connector only by the housing to plug or unplug a fiber-optic cable.
The transceiver modules and fiber connectors are keyed to prevent incorrect insertion.
Note
Hardware Installation Guide for Cisco 8500 Switches
63
Connect Switch to the Network
Attach the Optical Network Cable
To Next Page
Loading...
