CHAPTER 6
Replace Chassis Components
The images in this chapter are only for representation purposes, unless specified otherwise. The chassis' actual
appearance and size may vary.
Note
Whenever you replace any card, you must always ensure to secure the ejector thumbscrews properly.
Caution
• Replace a System Control Module, on page 71
• Replace the Switch Main Board, on page 75
• Replace a Fan Module, on page 80
• Replace Power Module, on page 85
Replace a System Control Module
The Cisco 8501 switch supports a single System Control Module (SCM) (85-RP-O).
Statement 1090—Installation by Skilled Person
Only a skilled person should be allowed to install, replace, or service this equipment. See statement 1089 for
the definition of a skilled person.
There are no serviceable parts inside. To avoid risk of electric shock, do not open.
Warning
Statement 1091—Installation by an Instructed Person
Only an instructed person or skilled person should be allowed to install, replace, or service this equipment.
See statement 1089 for the definition of an instructed or skilled person.
There are no serviceable parts inside. To avoid risk of electric shock, do not open.
Warning
Hardware Installation Guide for Cisco 8500 Switches
71
To Next Page
Loading...
