To prevent an IP address conflict, do not connect the MGMT 100/1000 Ethernet port until the initial
configuration is complete.
Caution
Before you begin
You must have completed the initial switch configuration.
Procedure
Step 1 Connect a modular, RJ-45, UTP cable to the MGMT ETH port.
Step 2 Route the cable through the central slot in the cable management system.
Step 3 Connect the other end of the cable to a 100/1000 Ethernet port on a network device.
What to do next
You are ready to connect the interface ports to the network.
Transceivers, Connectors, and Cables
Transceiver and Cable Specifications
To determine which transceivers and cables are supported by this switch, see Cisco Transceiver Modules
Compatibility Information.
To see the transceiver specifications and installation information, see Cisco Transceiver Modules Install and
Upgrade Guides.
RJ-45 Connectors
The RJ-45 connector connects Category 3, Category 5, Category 5e, Category 6, or Category 6A foil twisted-pair
or unshielded twisted-pair cable from the external network to the following module interface connectors:
• Switch chassis
• CONSOLE port
• MGMT ETH port
To comply with GR-1089 intrabuilding, lightning immunity requirements, you must use a foil twisted-pair
(FTP) cable that is properly grounded at both ends.
Caution
Hardware Installation Guide for Cisco 8500 Switches
55
Connect Switch to the Network
Transceivers, Connectors, and Cables
To Next Page
Loading...
