Cisco 8500 - Procure Tools and Equipment; Switch Accessory Kit

• Each port must match the wave-length specifications on each end of the cable, and the cable must not
exceed the stipulated cable length.
Cisco 8000 Switches function in operating temperatures of up to 35°C at sea level. For every 300 meters
(1000 ft) elevation upto 1800 meters (6000 ft), the maximum temperature is reduced by 1°C. For more details
on environmental requirements, see Cisco 8100 Router Data Sheet.
Note
Procure Tools and Equipment
Obtain these necessary tools and equipment for installing the chassis:
• Number 1 and number 2 Phillips screwdrivers with torque capability to rack-mount the chassis.
• 3/16-inch flat-blade screwdriver.
• Tape measure and level.
• ESD wrist strap or other grounding device.
• Antistatic mat or antistatic foam.
• Single Radsok grounding connector (1).
• Wire-stripping tool.
Switch Accessory Kit
Switch accessory kit for the Cisco 8501 switch includes the following:
Table 4: 85-ACKIT
QuantityDescription
2AC power cable
2AC power module
Table 5: 85-DCKIT
QuantityDescription
1DC power cable
1DC power module
1PSU blank card
Hardware Installation Guide for Cisco 8500 Switches
17
Prepare for Installation
Procure Tools and Equipment