Figure 16: Attach Bottom-Support Minipack3 Rails to a ORv3N Rack
Note
Use at least two screws on each end of each bottom-support rail.
Step 3 Repeat Steps 1 and 2 to attach the other bottom-support rail to the rack.
Note
Make sure that the two bottom-support rails are level with one another using a measuring tape. If they are not
level, adjust the higher rail down to the level of the lower rail.
What to do next
Mount the chassis into the rack.
Hardware Installation Guide for Cisco 8500 Switches
26
Unpack and Install the Chassis
Install Bottom-Support Rails
To Next Page
Loading...
