Ejector lever handle1
Ejector lever latch2
Procedure
Step 1 Open the packaging for the new SCM and inspect it for damage.
If the SCM is damaged, contact the Technical Assistance Center (TAC).
Step 2 If you are replacing a SCM that is currently in the chassis, remove the existing SCM from the chassis by
following these steps:
a) Disconnect and label each of the interface cables from the SCM.
b) Simultaneously press the latch on the ejector lever and pull the ejector lever.
Figure 47: SCM Components
Ejector lever handle1
Ejector lever latch2
c) Use the ejector lever to pull the SCM a couple of inches (about 5 cm) from the chassis.
d) Close the ejector lever until the ejector lever latch clicks into place.
Hardware Installation Guide for Cisco 8500 Switches
73
Replace Chassis Components
Replace a System Control Module
To Next Page
Loading...
