Cisco 8821

Procedure
Step 1
From the phone administration web page, select WLAN.
Step 2
Set the fields as described in the following table.
DescriptionField Name
Read-only fieldSource
Use to enable or disable the profile.Status
Enter the name of the profile.Profile
Set the field to enable or disable the user from
changing their WLAN profile.
User modifiable
WLAN configuration
Enter the SSID of the access point.SSID
Select a security mode.Security mode
When the security type is set to WEP, the screen
changes to display the WEP key field. enter a 40/104
or 64/128 ASCII or Hex WEP key.
WEP key
When the security type is set to PSK, the screen
changes to display the Passphrase field. Enter an
8-63 ASCII or 64Hex passphrase.
Passphrase
When the security type is EAP-Fast, PEAP-GTC, or
PEAP-MSCHAPV2, the screen changes to display
the User ID field. Enter the id of the user.
User ID
When the security type is EAP-Fast, PEAP-GTC, or
PEAP-MSCHAPV2, the screen changes to display
the Password field. Enter a password.
Password
Select the mode required.802.11 mode
Select the type of power save mode that the phone
uses to save power.
On call power save
Network configuration
Enter the domain name.Domain name
IPv4
Cisco Wireless IP Phone 8821 and 8821-EX Administration Guide for Cisco Unified Communications Manager
71
Configuration on the Phone
Set Up the Phone with the Administration Web Page