Call buttonSoftkey 4Softkey 3Softkey 2Softkey 1Call State
On hookMore1AppsEnd CallHoldConnected
(multiple calls)
More2TransferSwap or
Calls
Contacts
TopParkConfListConf
The ConfList softkey displays only if you are in a conference.Note
The Calls softkey displays when more than two calls are connected. Pressing Calls loads a call list.Note
Survivable Remote Site Telephony overview
If communication between the conference station and the Cisco Unified Communications Manager is
interrupted, you receive an alert message on your phone. If you are on an active call, the call remains established,
and you enter a failover situation. The Survivable Remote Site Telephony (SRST) feature handles this failover.
While in failover, not all the features of conference station are available. The following table describes typical
features and feature availability. For more information about feature availability during failover, contact your
system administrator.
When the conference station loses connectivity, it may display a message similar to this: SRST. Some
features unavailable.
Table 11: Feature support during Failover
NotesSupportedFeature
YesNew Call
YesEnd Call
YesRedial
YesAnswer
YesHold
YesResume
Cisco Unified IP Conference Phone 8831 User Guide for Cisco Unified Communications Manager 9.0
39
Calling features
Survivable Remote Site Telephony overview
To Next Page
Loading...
Need help?
General
