Cisco Aironet 1300 Series - Page 38

CISCO CONFIDENTIAL - First Draft
3-4
Cisco Aironet 1300 Series Bridge Hardware Installation Guide
OL-5048-01
Chapter 3 Mounting and Alignment Overview
Bridge LEDs
The LEDs are mounted on the back of the housing (see Figure 3-1).
Figure 3-1 Bridge LEDs
When the bridge is initially powered-up, installation mode is activated and the bridge attempts to
associate to a root bridge for 60 seconds. If it is unable to associate with a root bridge, it automatically
assumes the root bridge role. The Install LED provides bridge association status during installation mode
as shown in Table 3-2.
1 Radio LED (R) 3 Ethernet LED (E)
2 Status LED (S) 4 Install LED (I)
Table 3-2 Install LED Association Status
Install LED State Bridge State
Off Self test Startup.
Amber blinking Non-root, searching Not associated (non-root mode). The
bridge attempts to associate with a root
bridge for 60 seconds
1
.
1. Preconfigured bridges search indefinitely.
Amber Non-root, associated Associated (non-root mode).
Green blinking Root, searching Not associated (root mode). The bridge
attempts to associate with a non-root
bridge indefinitely.
Green Root, associated Associated (root mode).