Broadcast message from root (pts/2) Wed May 11 16:08:16 2016...
The system is going down for reboot NOW !!
Employing the ignore-locks keyword when rebooting the system may corrupt the configuration file.Caution
show administrators Command
The Exec mode show administrators command has a single-character "M" column that indicates the current
lock mode for the administrator’s session. The M-mode characters are defined as follows:
• [blank] – Administrator is in Exec mode
• c – Administrator session is currently in Config Mode (shared-lock)
• s – Administrator session is currently saving the config
• f – Administrator session is currently loading the config file
• L – Administrator session is currently in Config Mode with the exclusive-lock
The following is sample output of the show administrators command indicating current lock mode:
[local]asr5500# show administrators
Administrator/Operator Name M Type TTY Start Time
------------------------------ - ------- -------------- ------------------------
Bob admin /dev/pts/2 Tue Mar 29 11:51:15 2016
Alice c admin /dev/pts/1 Mon Mar 28 14:41:15 2016
Carol admin /dev/pts/0 Mon Mar 28 14:40:52 2016
ASR 5500 System Administration Guide, StarOS Release 21.4
87
Config Mode Lock Mechanisms
show administrators Command
To Next Page
Loading...
Need help?
General
