Cisco ASR 5500 User Manual

Enabling BFD on OSPF Interfaces
All OSPF Interfaces
config
context context_name
router ospf
bfd-all-interfaces
Specific OSPF Interface
config
context context_name
interface interface_name
broadcast
ip ospf bfd
Monitoring BFD Connection for ICSR
For ICSR configurations, the following command sequence initiates monitoring of the connection between
the primary chassis and the BFD neighbor in the specified context. If the connection drops, the standby chassis
becomes active.
config
context context_name
service-redundancy-protocol
monitor bfd context context_name { ipv4_address | ipv6_address } { chassis-to-chassis |
chassis-to-router }
Notes:
•
ipv4 _address | ipv6_address defines the IP address of the BFD neighbor to be monitored, entered using
IPv4 dotted-decimal or IPv6 colon-separated-hexadecimal notation
•
chassis-to-chassis enables BFD to run between primary and backup chassis on non-SRP links.
•
chassis-to-router enables BFD to run between chassis and router.
Saving the Configuration
Save your configuration as described in the Verifying and Saving Your Configuration chapter.
Chassis-to-Chassis BFD Monitoring for ICSR
An operator can configure BFD to more quickly advertise routes during an ICSR switchover. This solution
complements the feature that allows the advertising of BGP routes from a Standby ICSR chassis. The overall
goal is to support more aggressive failure detection and recovery in an ICSR configuration when implementing
of VoLTE.
You must configure the following features for chassis-to-chassis BFD monitoring in ICSR configurations:
ASR 5500 System Administration Guide, StarOS Release 21.4
291
Routing
Chassis-to-Chassis BFD Monitoring for ICSR

Cisco ASR 5500 Specifications

General

Brand	Cisco
Model	ASR 5500
Category	Network Router
Language	English