BGP CLI Configuration Commands 284
Confirming BGP Configuration Parameters 286
Bidirectional Forwarding Detection 286
Overview of BFD Support 287
Configuring BFD 287
Configuring a BFD Context 288
Configuring IPv4 BFD for Static Routes 288
Configuring IPv6 BFD for Static Routes 288
Configuring BFD for Single Hop 289
Configuring Multihop BFD 289
Scaling of BFD 290
Associating BGP Neighbors with the Context 290
Associating OSPF Neighbors with the Context 290
Associating BFD Neighbor Groups with the BFD Protocol 290
Enabling BFD on OSPF Interfaces 291
All OSPF Interfaces 291
Specific OSPF Interface 291
Monitoring BFD Connection for ICSR 291
Saving the Configuration 291
Chassis-to-Chassis BFD Monitoring for ICSR 291
Enable Primary Chassis BFD Monitoring 292
Set BFD to Ignore ICSR Dead Interval 292
Configure ICSR Switchover Guard Timer 292
Enable BFD Multihop Fall-over 293
ip route Command 293
ip routev6 Command 294
Adjust BFD Interval 294
Enable Advertising BGP Routes from Standby ICSR Chassis 294
Saving the Configuration 294
BFD Support for Link Aggregation Member Links 294
Overview 295
Configuring Support for BFD Linkagg Member-links 295
Saving the Configuration 296
Viewing Routing Information 296
ASR 5500 System Administration Guide, StarOS Release 21.4
xviii
Contents
To Next Page
Loading...
Need help?
General
