Cisco ASR 9010 Installation Guide

Step 4 Slide out the fan tray completely from the chassis while supporting it with your other hand.
Use two hands when handling the fan tray. The fan tray weighs about 11.0 pounds (4.99 kg).
Caution
Figure 83: Removing or Installing the Fan Tray on the Cisco ASR 9904 Router Chassis
Removing a Fan Tray from the Cisco ASR 9906 Router
Follow these steps to remove a fan tray from the Cisco ASR 9906 Router (see the figure below).
Procedure
Step 1 Loosen the screws that secure the fan tray door to the chassis and open the door.
Step 2 Loosen the captive installation screw on the front of the fan tray.
Step 3 Using the handle on the front panel, pull the fan tray halfway out of the chassis.
Step 4 Wait for all the fans to stop rotating.
Step 5 Slide out the fan tray completely from the chassis while supporting it with your other hand.
Use two hands when handling the fan tray. The fan tray weighs about 8.0 pounds (3.63 kg).
Caution
Cisco ASR 9000 Series Aggregation Services Router Hardware Installation Guide
79
Unpacking and Installing the Chassis
Removing a Fan Tray from the Cisco ASR 9906 Router

Cisco ASR 9010 Specifications

General

Chassis	Modular
Rack Units	21 RU
Operating System	Cisco IOS XR
Form Factor	Rack-mountable
Number of Slots	10
Power Supply	AC or DC
Redundancy	Yes
Slots	8 line card slots, 2 route switch processor slots
Memory	16 GB DRAM
Storage	64 GB SSD (Route Processor)
Port Types	Ethernet, OTN
Redundancy Features	Route Processor, Power Supply, Fan Tray
Operating Temperature	32 to 104°F (0 to 40°C)
Humidity	5% to 90% non-condensing
Route Processor	Cisco ASR 9000 Series Route Switch Processor