CHAPTER 5
Replacing Cisco ASR 9000 Series Router
Components
The router is equipped as ordered and is ready for installation and startup when it is shipped. As network
requirements change, you may need to upgrade the system by adding or changing components. This chapter
describes how to maintain router components.
• Prerequisites and Preparation, on page 221
• Replacing the Chassis Air Filter, on page 224
• Removing and Replacing the Fan Trays, on page 230
• Removing and Replacing Power System Components, on page 232
• Removing and Replacing Cards from the Chassis, on page 245
• Migrating from RP1 to RP2 Card, on page 248
• Migrating from RP2 to RP3 Card, on page 250
• Migrating from RSP440 to RSP880 or RSP880-LT Card , on page 253
• Migrating from RSP4-S to RSP880-LT Card (ASR 9906 Router), on page 256
• Migrating from RSP4/RSP4-S/RSP-L to RSP5 Card, on page 258
• Migrating from FC1 to FC2 Card, on page 261
• Migrating from A99-SFC2 to A99-SFC3 Card, on page 262
• Migrating from A99-SFC-S/A99-SFC-T to A99-SFC3-S/A99-SFC3-T Card, on page 262
• Removing a Chassis from the Equipment Rack, on page 263
• Installing a Replacement Chassis in the Equipment Rack, on page 264
• Packing a Chassis for Shipment, on page 265
Prerequisites and Preparation
Before you perform any of the procedures in this chapter, be sure that you:
• Review the Safety Guidelines, on page 1.
• Read the safety and ESD-prevention guidelines described in Compliance and Safety Information, on
page 2.
• Ensure that you have all the necessary tools and equipment before beginning the procedure.
Have access to the safety and compliance document during the installation, see:
http://www.cisco.com/en/US/docs/routers/asr9000/hardware/rcsi/regulatory/compliance/asr9krcsi.html
Cisco ASR 9000 Series Aggregation Services Router Hardware Installation Guide
221
To Next Page
Loading...
Need help?
General
