1-5
Catalyst 3560 Switch Hardware Installation Guide
78-16057-01
Chapter 1 Using Express Setup
Starting Express Setup
Follow these steps to start the Express Setup program:
Step 1 Verify that no devices are connected to the switch.
Step 2 Press and hold the Mode button, as shown in Figure 1-4, until the LEDs above the
Mode button turn green. This takes approximately 3 seconds.
Figure 1-4 Starting Express Setup
Step 3
Release the Mode button.
Note If all of the LEDs begin to blink after you press the Mode button, release it.
Blinking LEDs mean that the switch has already been configured and cannot go
into Express Setup mode. For more information, see the “Clearing the Switch IP
Address and Configuration” section on page 4-2.
1 Mode button
SYST
RPS
STAT
DUPLX
SPEED
PoE
MODE
1
2
5
6
7
8
9
10
11
12
13
14
15
16
3
4
1X
2X
15X
16X
97909
1
To Next Page
Loading...
