3-8
Catalyst 3650 Switch Hardware Installation Guide
OL-29734-01
Appendix 3 Configuring the Switch with the CLI-Based Setup Program
Entering the Initial Configuration Information
You have completed the initial configuration of the switch, and the switch displays its configuration.
This is an example of the configuration output:
The following configuration command script was created:
hostname switch1
enable secret 5 $1$Ulq8$DlA/OiaEbl90WcBPd9cOn1
enable password enable_password
line vty 0 15
password terminal-password
no snmp-server
!
no ip routing
!
interface Vlan1
no shutdown
ip address 10.4.120.106 255.0.0.0
!
interface GigabitEthernet4/0/1
!
interface GigabitEthernet4/0/2
interface GigabitEthernet4/0/3
!
...<output abbreviated>
!
!
end
Step 11 After you complete the initial configuration of the switch, these choices are displayed:
[0] Go to the IOS command prompt without saving this config.
[1] Return back to the setup without saving this config.
[2] Save this configuration to nvram and exit.
If you want to save the configuration and use it the next time the switch reboots, select
option 2 to save it in nonvolatile RAM (NVRAM).
Enter your selection [2]:2
Step 12 Make your selection, and press Return.
After you complete the setup program, the switch can run the default configuration that you created. To
change this configuration or to perform other management tasks, enter commands at the
Switch> prompt,
or use the Cisco Network Assistant, or another management tool for further configuration.
To Previous Page
Loading...
Need help?
General
