Cisco Catalyst 3650 Series Hardware Installation Guide

Contents
iv
Catalyst 3650 Switch Hardware Installation Guide
OL-29734-01
Power Supply Module LEDs 1-35
RPS Connector 1-35
Cisco RPS 2300 1-36
Fan Modules 1-36
Fan Airflow for Catalyst 3650-24PDM and Catalyst 3650-48FQM Switches 1-37
Management Ports 1-37
Ethernet Management Port 1-37
RJ-45 Console Port 1-38
Management Options 1-38
Network Configurations 1-39
CHAPTER 2 Switch Installation 2-1
Preparing for Installation 2-1
Safety Warnings 2-1
Installation Guidelines 2-3
Tools and Equipment 2-4
Verifying Switch Operation 2-4
Powering Off the Switch 2-5
Planning a Switch Data Stack 2-5
Switch Stacking Guidelines 2-5
Data Stack Cabling Configurations 2-6
Data Stack Bandwidth and Partitioning Examples 2-6
Power-On Sequence for Switch Data Stacks 2-8
Changes to Switch Stack Membership 2-8
Installing the Switch 2-9
Rack-Mounting a Switch 2-9
Attaching the Rack-Mount Brackets 2-11
Mounting the Switch in a Rack 2-14
Table-Mounting or Shelf-Mounting 2-15
After Installing the Switch 2-15
Installing the StackWise Ports 2-16
Installing and Removing an SFP and SFP+ Module 2-18
Installing an SFP and SFP+ Module 2-18
Removing an SFP or SFP+ Module 2-20
Connecting a Device to an Ethernet Port 2-20
10/100/1000 Ethernet Port Connections 2-20
100M/1G/2.5G/5G/10G Ethernet Port Connections 2-21
PoE+ Port and Cisco UPOE Connections 2-21
Where To Go Next 2-22

Cisco Catalyst 3650 Series Specifications

General

RAM	4 GB
Flash Memory	4 GB
Ports	24 or 48 10/100/1000 Ethernet ports
Uplinks	4 x 1G SFP or 4 x 10G SFP+ (depending on model)
Stacking	Up to 9 switches with StackWise-160
Layer Support	Layer 2, Layer 3
Software	Cisco IOS Software
Power Supply	Internal power supply; optional redundant power supply available
Storage Temperature	-40°F to 158°F (-40°C to 70°C)