Cisco Catalyst 6500 Series User Manual

xxiv
Catalyst 6500 Series Switch and Cisco 7600 Series Router Firewall Services Module Configuration Guide
OL-6392-01
Quick Start Steps
Routed Firewall Configuration Steps
Step 10
Configure routing using one of these methods:
• Configuring Static Routes, page 8-3
• (Single context mode only) Configuring OSPF, page 8-4
• (Single context mode only) Configuring RIP, page 8-18
In multiple context mode, static routing is the only
routing method supported. In single mode, you have
a choice of static, RIP, or OSPF. RIP support is for
passive mode only.
Step 11
Use one or more of these NAT methods:
• Using Dynamic NAT and PAT, page 9-16
• Using Static NAT, page 9-26
• Using Static PAT, page 9-27
• Bypassing NAT, page 9-29
You must specifically configure some interfaces to
either use or bypass NAT. Typically, if you want to
allow inside users to access the outside or other
networks attached to the FWSM, configure dynamic
NAT or PAT according to the “Using Dynamic NAT
and PAT” section on page 16. If you want to allow
outside users to access an inside host, then configure
static NAT according to the “Using Static NAT”
section on page 26.
The FWSM offers a large amount of flexibility in
your NAT configuration.
Step 12
Adding an Extended Access Control List, page 10-13 Before any traffic can go through the FWSM, you
must create an ACL that permits traffic, and then
apply it to an interface.
Task Description

Cisco Catalyst 6500 Series Specifications

General

Brand	Cisco
Model	Catalyst 6500 Series
Category	Switch
Language	English