Cisco Catalyst 6500 Series User Manual

Contents
vii
Catalyst 6500 Series Switch and Cisco 7600 Series Router Firewall Services Module Configuration Guide
OL-6392-01
Configuring OSPF 8-4
OSPF Overview 8-4
Enabling OSPF 8-5
Redistributing Routes Between OSPF Processes 8-6
Adding a Route Map 8-6
Redistributing Static, Connected, or OSPF Routes to an OSPF Process 8-8
Configuring OSPF Interface Parameters 8-9
Configuring OSPF Area Parameters 8-11
Configuring OSPF NSSA 8-12
Configuring Route Summarization Between OSPF Areas 8-13
Configuring Route Summarization When Redistributing Routes into OSPF 8-14
Generating a Default Route 8-14
Configuring Route Calculation Timers 8-15
Logging Neighbors Going Up or Down 8-15
Displaying OSPF Update Packet Pacing 8-16
Monitoring OSPF 8-16
Restarting the OSPF Process 8-17
Configuring RIP 8-18
RIP Overview 8-18
Enabling RIP 8-18
Configuring the DHCP Server 8-19
Enabling the DHCP Server 8-19
Using Cisco IP Phones with a DHCP Server 8-20
Configuring DHCP Relay 8-21
CHAPTER 9 Configuring Network Address Translation 9-1
NAT Overview 9-1
Introduction to NAT 9-2
NAT Types 9-3
Dynamic NAT 9-3
PAT 9-4
Static NAT 9-5
Static PAT 9-5
Bypassing NAT 9-7
Policy NAT 9-8
Outside NAT 9-10
NAT and Same Security Level Interfaces 9-11
Order of NAT Commands Used to Match Local Addresses 9-12
Maximum Number of NAT Statements 9-12

Cisco Catalyst 6500 Series Specifications

General

Brand	Cisco
Model	Catalyst 6500 Series
Category	Switch
Language	English