Contents
vi
Catalyst 6500 Series Switch and Cisco 7600 Series Router Firewall Services Module Configuration Guide
OL-6392-01
Viewing Context Information 5-25
Viewing Resource Allocation 5-26
Viewing Resource Usage 5-28
Monitoring SYN Attacks using TCP Intercept 5-29
CHAPTER
6 Configuring Basic Settings 6-1
Changing the Passwords 6-1
Changing the Login Password 6-2
Changing the Enable Password 6-2
Changing the Maintenance Partition Passwords 6-2
Setting the Host Name 6-4
Setting the Domain Name 6-5
Adding a Login Banner 6-5
Configuring Interfaces 6-6
Security Level Overview 6-6
Setting the Name and Security Level 6-7
Allowing Communication Between Interfaces on the Same Security Level 6-8
Turning Off and Turning On Interfaces 6-10
Configuring Connection Limits for Non-NAT Configurations 6-10
CHAPTER
7 Configuring Bridging Parameters and ARP Inspection 7-1
Customizing the MAC Address Table 7-1
MAC Address Table Overview 7-1
Adding a Static MAC Address 7-2
Setting the MAC Address Timeout 7-2
Disabling MAC Address Learning 7-2
Viewing the MAC Address Table 7-3
Configuring ARP Inspection 7-3
ARP Inspection Overview 7-3
Adding a Static ARP Entry 7-4
Enabling ARP Inspection 7-4
CHAPTER
8 Configuring IP Addresses, Routing, and DHCP 8-1
Configuring IP Addresses 8-1
Assigning IP Addresses to Interfaces for a Routed Firewall 8-2
Setting the Management IP Address for a Transparent Firewall 8-2
Configuring the Default Route 8-2
Configuring Static Routes 8-3
To Next Page
Loading...
