DescriptionFeature
1:1 (When all eight 10G ports are used.)Module oversubscription rate
Supervisor Engine 2T-10GESupervisor engine support
With Supervisor Engine 2T-10GE —Cisco IOS Release 15.2(1)SY
or later
Software support
With a WS-F6K-DFC4-E/ EXL daughter card:
• Tx—1p7q4t
• Rx—1p7q4t
Queues per port
The following restrictions apply to module installation and
operation:
• Module installation—Modules must be installed in adjacent
slots. To maintain adequate air flow through the chassis,
install a switching-module filler plate (Cisco part number
WS-X6K-SLOT-CVR-E=) in unused slots, rather than a
blank slot cover (Cisco part number
WS-X6K-SLOT-CVR=).
• Module operation—The C6800-8P10G/ 10G-XL operates
only in a Cisco Catalyst 6807-XL and a Cisco Catalyst 6500
E-series chassis equipped with a Supervisor Engine
2T-10GE.
• Slot restrictions—In the following switch chassis, you
cannot install Ethernet modules in slots meant for supervisor
engines:
•
In a Cisco Catalyst 6807-XL, the supervisor engine
slots are 3 and 4.
•
In a Cisco Catalyst 6513 E-series chassis, the
supervisor engine slots are 7 and 8. This restriction
does not apply to any other 6500 E-series chassis.
Chassis and slot restrictions
For Cisco Catalyst 6807-XL switches:
•
Fabric channel 0 : Ports 1 to 4
•
Fabric channel 1: Ports 5 to 8
For Cisco Catalyst 6500-E series switches:
•
Fabric channel 0 : Ports 1 to 4
•
Fabric channel 1: Ports 5 to 8
Fabric connection
Catalyst 6800 Ethernet Module Installation Guide
8
Ethernet Switching Modules Overview
C6800-8P10G and C6800-8P10G-XL Ethernet Modules
To Next Page
Loading...
