Connecting Transceivers to a Copper Network
To comply with GR-1089 intrabuilding lightning immunity requirements, you must use grounded, shielded,
twisted-pair Category 5 cabling.
Caution
Step 1
Insert the network cable RJ-45 connector into the RJ-45 connector on the transceiver.
When connecting to a 1000BASE-T-compatible switch or repeater, use four-twisted-pair, crossover Category 5 cabling.
Step 2
Insert the other end of the network cable into an RJ-45 connector on a 1000BASE-T-compatible target device.
Verifying the Installation
Verifying Newly Installed Modules
Enter the show module or show port [modnum/port_num] privileged EXEC command.
This verifies that the system acknowledges the new modules and has brought them online.
What to Do Next
Enter the ping host user EXEC command to ping a host and check connectivity.
If the host is unresponsive, check the IP address of the switch and default IP route, if appropriate.
Example: show module Command Output for C6800-48P-TX-XL
These are examples of the show module command output for the C6800-48P-TX-XL Ethernet module:
Switch# show module sw 1
Switch Number: 1 Role: Virtual Switch Standby
---------------------- -----------------------------
Mod Ports Card Type Model Serial No.
--- ----- -------------------------------------- ------------------ -----------
1 20 DCEF2T 4 port 40GE / 16 port 10GE WS-X6904-40G SAL1624E826
2 4 WiSM 2 WLAN Service Module WS-SVC-WISM2-K9 SAL1523FLRV
3 5 Supervisor Engine 2T 10GE w/ CTS (CSSO VS-SUP2T-10G SAL17152F6Q
4 5 Supervisor Engine 2T 10GE w/ CTS (Hot) VS-SUP2T-10G SAL17152F7C
5 4 Network Analysis Module 3 WS-SVC-NAM-3-K9 SAL16127XFD
6 48 DCEF-XL 48P 10/100/1000MB Ethernet C6800-48P-TX-XL SAL1736CC7W
Mod MAC addresses Hw Fw Sw Status
--- ---------------------------------- ------ ------------ ------------ -------
1 1cdf.0f9b.df26 to 1cdf.0f9b.df39 1.0 12.2(50r)SYL 15.1(2)SY2 Ok
2 e05f.b994.2660 to e05f.b994.266f 1.0 12.2(18r)S1 15.1(2)SY2 Ok
3 2c54.2dc4.a0a5 to 2c54.2dc4.a0ac 1.5 12.2(50r)SYS 15.1(2)SY2 Ok
4 2c54.2dc3.7499 to 2c54.2dc3.74a0 1.5 12.2(50r)SYS 15.1(2)SY2 Ok
5 1cdf.0f9b.a76e to 1cdf.0f9b.a77d 1.1 12.2(50r)SYL 15.1(2)SY2 Ok
6 7c69.f69b.c8d8 to 7c69.f69b.c907 0.1 12.2(18r)S1 15.1(2)SY2 Ok
Catalyst 6800 Ethernet Module Installation Guide
34
Installing and Removing Modules, Transceivers, and Attaching Cables
Connecting Transceivers to a Copper Network
To Next Page
Loading...
