Cisco Catalyst 6800 - Module Connectors

More InformationSupported on These ModulesDescriptionWDM
Transceiver
Type
•
Cisco 10GBASE
Dense
Wavelength-Division
Multiplexing SFP+
Modules Data Sheet
•
Cisco OneX
Converter Module
•
Cisco 40GBASE CFP
Modules Data Sheet
You an use these 10-GB modules
with the Cisco OneX Converter
Module
12
•
C6800-8P10G
•
C6800-8P10G-XL
•
C6800-16P10G
•
C6800-16P10G-XL
•
C6800-32P10G
•
C6800-32P10G-XL
•
WS-X6816-10G
•
WS-X6816-10G XL
•
WS-X6908-10
•
WS-X6908-10 XL
•
VS-S2T-10G
•
VS-S2T-10G XL
You can also use these 40-GB
modules with the Cisco FourX
Converter Module
13
:
•
WS-X6904-40G-2T
•
WS-X6904-40G-2TXL
The Cisco DWDM SFP+
transceiver module is a
hot-swappable I/O device that
you can plug into an Ethernet
SFP+ port of a Cisco switch or
router to link the port with the
network. It supports 40
nontunable ITU 100-GHz
wavelengths. It also supports
digital optical monitoring
capability and the Cisco
quality identification (ID)
feature, which enables a Cisco
switch or router to identify
whether or not the module is
an SFP+ module certified and
tested by Cisco.
DWDM
SFP+
12
CVR-X2-SFP10G —Converter for X2 ports.
13
CVR-CFP-4SFP10G.
To determine if a specific WDM transceiver is compatible with the supported modules, see the Cisco
Gigabit Ethernet Transceiver Modules Compatibility Matrix document that is available on Cisco.com.
Note
Module Connectors
This section provides brief descriptions of the module connectors that the switch supports.
Related Topics
Installing Transceivers and Module Connectors, on page 31
Catalyst 6800 Ethernet Module Installation Guide
51
Pluggable Transceivers, Module Connectors
Module Connectors