Cisco Catalyst 6800 User Manual

•
No. 1 Phillips screwdriver.
•
Crimping tool to crimp the grounding wire to the grounding lug.
•
Wire-stripping tool to remove the insulation from the grounding wire.
SUMMARY STEPS
1.
Use a wire-stripping tool to remove approximately 0.75 inches (19 mm) of the covering from the end of
the grounding wire.
2.
Insert the stripped end of the grounding wire into the open end of the right-angled grounding lug.
3.
Crimp the grounding wire in the barrel of the grounding lug. Verify that the ground wire is securely
attached to the ground lug.
4.
Secure the grounding lug to the system ground connector with two M4 screws. Ensure that the grounding
lug and the grounding wire do not interfere with other switch hardware or rack equipment.
5.
Prepare the other end of the grounding wire, and connect it to an appropriate grounding point in your site
to ensure adequate earth ground for the switch.
Catalyst 6800 Ethernet Module Installation Guide
19
Preparing for Installation
Establishing System Ground

Cisco Catalyst 6800 Specifications

General

Brand	Cisco
Model	Catalyst 6800
Category	Server
Language	English