EasyManua.ls Logo

Cisco Catalyst 9200

Cisco Catalyst 9200
276 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
CHAPTER 5
Configuring SDM Templates
Information About SDM Templates, on page 113
SDM Templates and Switch Stacks, on page 113
How to Configure SDM Templates, on page 114
Monitoring and Maintaining SDM Templates, on page 115
Configuration Examples for SDM Templates, on page 115
Additional References for SDM Templates, on page 117
Feature History for SDM Templates, on page 117
Information About SDM Templates
You can use SDM templates to configure system resources to optimize support for specific features, depending
on how your device is used in the network. You can select a template to provide maximum system usage for
some functions.
Cisco Catalyst 9200 Series Switches support the following templates:
Advanced
VLAN
It is recommended that you reload the system as soon as you make a change to the SDM template. After you
change the template and the system reboots, you can use the show sdm prefer privileged EXEC command
to verify the new template configuration. If you enter the show sdm prefer command before you enter the
reload privileged EXEC command, the show sdm prefer command shows the template currently in use
and the template that will become active after a reload.
SDM Templates and Switch Stacks
In a switch stack, all stack members must use the same SDM template that is stored on the active switch.
When a new switch is added to a stack, the SDM configuration that is stored on the active switch overrides
the template configured on an individual switch.
You can use the show switch privileged EXEC command to see if any stack members are in SDM mismatch
mode.
System Management Configuration Guide, Cisco IOS XE Gibraltar 16.10.x (Catalyst 9200 Switches)
113

Table of Contents

Related product manuals