EasyManua.ls Logo

Cisco Catalyst 9200

Cisco Catalyst 9200
276 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
Configuring the Client to Download Files from DHCP Server
You should only configure and enable the Layer 3 interface. Do not assign an IP address or DHCP-based
autoconfiguration with a saved configuration.
Note
SUMMARY STEPS
1. configure terminal
2. boot host dhcp
3. boot host retry timeout timeout-value
4. banner config-save ^C warning-message ^C
5. end
6. show boot
DETAILED STEPS
PurposeCommand or Action
Enters global configuration mode.configure terminal
Example:
Step 1
Device# configure terminal
Enables autoconfiguration with a saved configuration.boot host dhcp
Example:
Step 2
Device(conf)# boot host dhcp
(Optional) Sets the amount of time the system tries to
download a configuration file.
boot host retry timeout timeout-value
Example:
Step 3
If you do not set a timeout, the system will try
indefinitely to obtain an IP address from the
DHCP server.
Note
Device(conf)# boot host retry timeout 300
(Optional) Creates warning messages to be displayed when
you try to save the configuration file to NVRAM.
banner config-save ^C warning-message ^C
Example:
Step 4
Device(conf)# banner config-save ^C Caution -
Saving Configuration File
to NVRAM May Cause You to No longer Automatically
Download Configuration Files at Reboot^C
Returns to privileged EXEC mode.end
Example:
Step 5
System Management Configuration Guide, Cisco IOS XE Gibraltar 16.10.x (Catalyst 9200 Switches)
68
Performing Device Setup Configuration
Configuring the Client to Download Files from DHCP Server

Table of Contents

Related product manuals