PurposeCommand or Action
System configuration has been modified. Save?
the reason for the reload in a string up to 255 characters in
length.
[yes/no]: y
Specifies the time in hours and minutes for the reload to
occur.
reload at hh: mm [month day | day month] [text]
Example:
Step 4
Use the at keyword only if the device system
clock has been set (through Network Time
Protocol (NTP), the hardware calendar, or
manually). The time is relative to the configured
time zone on the device. To schedule reloads
across several devices to occur simultaneously,
the time on each device must be synchronized
with NTP.
Note
Device(config)# reload at 14:00
Cancels a previously scheduled reload.reload cancel
Example:
Step 5
Device(config)# reload cancel
Displays information about a previously scheduled reload
or identifies if a reload has been scheduled on the device.
show reload
Example:
Step 6
show reload
Monitoring Device Setup Configuration
Examples: Displaying Software Bootup in Install Mode
This example displays software bootup in install mode:
switch: boot flash:packages.conf
Attempting to boot from [flash:packages.conf]
Located packages.conf
#
validate_package: SHA-1 hash:
expected 340D5091:2872A0DD:03E9068C:3FDBECAB:69786462
calculated 340D5091:2872A0DD:03E9068C:3FDBECAB:69786462
Image parsed from conf file is cat9k-rpboot.16.09.01.SPA.pkg
########################################################################################################################
Waiting for 120 seconds for other switches to boot
#######################################################################################################################
Switch number is 1
Restricted Rights Legend
Use, duplication, or disclosure by the Government is
System Management Configuration Guide, Cisco IOS XE Gibraltar 16.10.x (Catalyst 9200 Switches)
75
Performing Device Setup Configuration
Monitoring Device Setup Configuration
To Next Page
Loading...
Need help?
General
