Cisco Catalyst 9200

PurposeCommand or Action
Device> enable
Enters the global configuration mode.configure terminal
Example:
Step 2
Device# configure terminal
Sets the time zone.clock timezone zone hours-offset [minutes-offset]
Step 3
Example:
Internal time is kept in Coordinated Universal Time (UTC),
so this command is used only for display purposes and when
the time is manually set.
Device(config)# clock timezone AST -3 30
• zone—Enters the name of the time zone to be displayed
when standard time is in effect. The default is UTC.
• hours-offset—Enters the hours offset from UTC.
• (Optional) minutes-offset—Enters the minutes offset
from UTC. This available where the local time zone
is a percentage of an hour different from UTC.
Returns to privileged EXEC mode.end
Example:
Step 4
Device(config)# end
Verifies your entries.show running-config
Example:
Step 5
Device# show running-config
(Optional) Saves your entries in the configuration file.copy running-config startup-config
Example:
Step 6
Device# copy running-config startup-config
Configuring Summer Time (Daylight Saving Time)
To configure summer time (daylight saving time) in areas where it starts and ends on a particular day of the
week each year, perform this task:
SUMMARY STEPS
1. enable
System Management Configuration Guide, Cisco IOS XE Gibraltar 16.10.x (Catalyst 9200 Switches)
12
Administering the Device
Configuring Summer Time (Daylight Saving Time)