EasyManua.ls Logo

Cisco Catalyst 9200

Cisco Catalyst 9200
276 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
PurposeCommand or Action
Enters the global configuration mode.configure terminal
Example:
Step 2
Device# configure terminal
Adds a static address to the MAC address table.mac address-table static mac-addr vlan vlan-id interface
interface-id
Step 3
mac-addrSpecifies the destination MAC unicast
address to add to the address table. Packets with this
Example:
destination address received in the specified VLAN
are forwarded to the specified interface.
Device(config)# mac address-table
static c2f3.220a.12f4 vlan 4 interface
vlan-idSpecifies the VLAN for which the packet
with the specified MAC address is received. Valid
VLAN IDs are 1 to 4094.
gigabitethernet 1/0/1
interface-idSpecifies the interface to which the
received packet is forwarded. Valid interfaces include
physical ports or port channels. For static multicast
addresses, you can enter multiple interface IDs. For
static unicast addresses, you can enter only one
interface at a time, but you can enter the command
multiple times with the same MAC address and VLAN
ID.
Verifies your entries.show running-config
Example:
Step 4
Device# show running-config
(Optional) Saves your entries in the configuration file.copy running-config startup-config
Example:
Step 5
Device# copy running-config startup-config
Configuring Unicast MAC Address Filtering
Follow these steps to configure the Device to drop a source or destination unicast static address:
SUMMARY STEPS
1. enable
2. configure terminal
3. mac address-table static mac-addr vlan vlan-id drop
4. end
5. show running-config
System Management Configuration Guide, Cisco IOS XE Gibraltar 16.10.x (Catalyst 9200 Switches)
38
Administering the Device
Configuring Unicast MAC Address Filtering

Table of Contents

Related product manuals