8. copy running-config startup-config
DETAILED STEPS
PurposeCommand or Action
Enables privileged EXEC mode. Enter your password if
prompted.
enable
Example:
Step 1
Device> enable
Enters the global configuration mode.configure terminal
Example:
Step 2
Device# configure terminal
Specifies the recipient of the trap message.snmp-server host host-addr {traps | informs} {version
{1 | 2c | 3}} community-string notification-type
Step 3
• host-addr—Specifies the name or address of the NMS.
Example:
• traps (the default)—Sends SNMP traps to the host.
Device(config)# snmp-server host
• informs—Sends SNMP informs to the host.
172.20.10.10 traps private mac-notification
• version—Specifies the SNMP version to support.
Version 1, the default, is not available with informs.
• community-string—Specifies the string to send with
the notification operation. Though you can set this
string by using the snmp-server host command, we
recommend that you define this string by using the
snmp-server community command before using the
snmp-server host command.
• notification-type—Uses the mac-notificationkeyword.
Enables the device to send MAC address move notification
traps to the NMS.
snmp-server enable traps mac-notification move
Example:
Step 4
Device(config)# snmp-server enable traps
mac-notification move
Enables the MAC address move notification feature.mac address-table notification mac-move
Example:
Step 5
Device(config)# mac address-table
notification mac-move
System Management Configuration Guide, Cisco IOS XE Gibraltar 16.10.x (Catalyst 9200 Switches)
34
Administering the Device
Configuring MAC Address Move Notification Traps
To Next Page
Loading...
