The optional StackWise-320 kit for Catalyst 9300L and 9300LM Series models consists of two stack adapters
and a stacking cable. The default stacking cable is 0.5 m, however options of 1m and 3m are also available.
Table 50: Cisco StackWise-320 Accessories for C9300LM Series Switches
Product DescriptionProduct ID
Stacking adapter for C9300L and C9300LM Series
Switches that is used in conjunction with
STACK-T3A type cables
C9300L-STACK-A
50 cm stacking cable for C9300L and C9300LM
Series Switches
STACK-T3A-50CM
1 m stacking cable for C9300L and C9300LM Series
Switches
STACK-T3A-1M
3 m stacking cable for C9300L and C9300LM Series
Switches
STACK-T3A-3M
C9300LM Series Switches use only T3A type stacking cables.
Note
Table 51: StackWise Cables Minimum Bend Radius and Coiled Diameter
Minimum Coiled DiameterMinimum Bend RadiusCable LengthCable Part Number
Not applicable1.6 in. (41 mm)1.64 feet (0.5 m)STACK-T1-50CM
5.2 in. (132 mm)1.6 in. (41 mm)3.28 feet (1.0 m)STACK-T1-1M
7.17 in. (182 mm)3.2 in. (82 mm)9.84 feet (3.0 m)STACK-T1-3M
Not applicable1.6 in. (41 mm)1.64 feet (0.5 m)STACK-T3-50CM
5.20 in. (132 mm)1.6 in. (41 mm)3.28 feet (1.0 m)STACK-T3-1M
7.17 in. (182 mm)3.2 in. (82 mm)9.84 feet (3.0 m)STACK-T3-3M
Not applicable1.6 in. (41 mm)1.64 feet (0.5 m)STACK-T3A-50CM
5.20 in. (132 mm)1.6 in. (41 mm)3.28 feet (1.0 m)STACK-T3A-1M
7.17 in. (182 mm)3.2 in. (82 mm)9.84 feet (3.0 m)STACK-T3A-3M
1. With a 0.5 m cable, the minimum coiled diameter is negligible and the cable cannot be physically coiled
without exceeding the bending limit.
Transceiver Module Network Cables
For cabling specifications, refer to the following notes:
Cisco Catalyst 9300 Series Switches Hardware Installation Guide
125
Connector and Cable Specifications
Transceiver Module Network Cables
To Next Page
Loading...
