Cisco Catalyst 9300X

C9300-NM-2Y Module
Table 26: C9300-NM-2Y Module with 25G SFP28 Module
ActionInterface
Configure this interfaceTwentyFiveGigabitEthernet1/1/1
Configure this interfaceTwentyFiveGigabitEthernet1/1/2
C9300-NM-8X Module
All ports in the C9300-NM-8X module default to 10 G and should be configured as TenGigabitEthernet1/1/1
through TenGigabitEthernet1/1/8, even when you are operating them as 1 G using SFP.
Table 27: C9300-NM-8-10X Module
ActionInterface
Configure this interfaceTenGigabitEthernet1/1/1
Configure this interfaceTenGigabitEthernet1/1/2
Configure this interfaceTenGigabitEthernet1/1/3
Configure this interfaceTenGigabitEthernet1/1/4
Configure this interfaceTenGigabitEthernet1/1/5
Configure this interfaceTenGigabitEthernet1/1/6
Configure this interfaceTenGigabitEthernet1/1/7
Configure this interfaceTenGigabitEthernet1/1/8
C9300X-NM-2C Module
Table 28: C9300X-NM-2C Module
ActionInterface
Configure this interfaceHundredGigE1/1/1
Configure this interfaceHundredGigE1/1/2
C9300X-NM-4C Module
Table 29: C9300X-NM-4C Module
ActionInterface
Configure this interfaceHundredGigE1/1/1
Configure this interfaceHundredGigE1/1/2
Cisco Catalyst 9300 Series Switches Hardware Installation Guide
74
Installing a Network Module
C9300-NM-2Y Module