Cisco Catalyst CW9800H1 - Page 5

Guidelines for a Standalone Equipment Shelf or Tabletop Installation 50
Installing the Controller on a Standalone Equipment Shelf or Tabletop 50
Guidelines for Rack Installation 51
Verifying Rack Dimensions 52
Attaching Front Rack-Mount Brackets 52
Mounting the Controller in the Rack 53
Two-Post Rack Installation 53
Four-Post Rack Installation 54
Attaching the Cable Management Bracket 55
Chassis Ground Connection 55
Recommended Tools and Supplies 56
Attaching a Chassis Ground Connection 56
Connecting Cables 57
Connecting the Console Port Cable 57
Procedure for Connecting the Console Port Cable 57
Connecting to the Micro USB Console Port 58
Management Ethernet Port Cable Connection 58
Power Up and Initial Configuration 59
CHAPTER 5
Checking Conditions Prior to System Startup 59
Powering Up the Controller 60
Performing the Initial Configuration on the Controller 60
Using the Cisco IOS-XE CLI - Cisco Setup Command Facility 60
Completing the Configuration 65
Using the Cisco IOS-XE CLI—Manual Configuration 66
Configuring the Controller Hostname 66
Configuring the Enable and Enable Secret Passwords 67
Configuring the Console Idle Privileged EXEC Timeout 68
Gigabit Ethernet Management Interface Overview 69
Default Gigabit Ethernet Configuration 70
Configuring Gigabit Ethernet Interfaces 70
Saving Your Controller Configuration 71
Verifying the Initial Configuration 72
Powering Off the Controller Safely 72
Cisco Catalyst CW9800H1 and CW9800H2 Wireless Controllers Hardware Installation Guide
v
Contents