CHAPTER 6
Safety Guidelines and Warnings
• Safety Instructions, on page 57
• FCC Safety Compliance Statement, on page 58
• Safety Precautions, on page 58
• Safety Precautions when Installing Antennas, on page 59
• Avoiding Damage to Radios in a Testing Environment, on page 59
• Performing Site Surveys, on page 60
Safety Instructions
The translated warnings are available in the Translated Safety Warnings for Cisco Catalyst Access Points,
which is available on Cisco.com.
IMPORTANT SAFETY INSTRUCTIONSThis warning symbol means danger. You are in a situation
that could cause bodily injury. Before you work on any equipment, be aware of the hazards involved
with electrical circuitry and be familiar with standard practices for preventing accidents. Use the
statement number provided at the end of each warning to locate its translation in the translated safety
warnings that accompanied this device.SAVE THESE INSTRUCTIONS Statement 1071
Warning
Read the installation instructions before using, installing or connecting the system to the power source.
Statement 1004
Warning
This product relies on the building’s installation for short-circuit (overcurrent) protection. Ensure that
the protective device is rated not greater than 20A. Statement 1005
Warning
Installation of the equipment must comply with local and national electrical codes. Statement 1074
Warning
Cisco Catalyst IW9167E Heavy Duty Access Point Hardware Installation Guide
57
To Next Page
Loading...
