Table 3: Supported SFP Modules
Operating Temperature
Range
Fiber/CableDistancePID
INDMMF220-550mGLC-SX-MM-RGD=
INDMMF/SMF550m/10kmGLC-LX-SM-RGD=
INDCAT 5e100mGLC-T-RGD=
INDSMF10kmSFP-10G-LR10-I
EXTCAT 6A/CAT 730m@10GbpsSFP-10G-T-X
1
1
SFP-10G-T-X is not in supported in Cisco IOS XE Release 17.9.3.
SFP modules are not hot-swappable. When you plug and unplug the SFP module, a manual reload of the AP
is required.
Note
Client data is passed to the network controller through the fiber connection via a fiber-capable switch or
controller. Configuration information can be found in the controller configuration guide of the switch or
controller you are using.
Antennas and Radios
The Cisco Catalyst IW9167E Heavy Duty Access Point configuration is:
• IW9167EH-x
The IW9167EH access point has eight N-type female connectors to support multiple antenna options, such
as the self-identifying antennas (SIA) on designated three SIA ports, dual-band antennas, and single-band
antennas. To see the list of supported antennas and the radio bands they operate at, see Supported External
Antennas, on page 8.
Supported External Antennas
The following figure shows the antenna ports of the IW9167EH access point.
Cisco Catalyst IW9167E Heavy Duty Access Point Hardware Installation Guide
8
About Cisco Catalyst IW9167E Heavy Duty Access Point
Antennas and Radios
To Next Page
Loading...
