Cisco Catalyst IW9167E - Connecting DC Power Port Using M12 Adapter

DC power port connected using cable gland3SFP port connected using cable gland1
RJ-45 port connected using cable gland2
Connecting DC Power Port Using M12 Adapter
Follow these steps to connect to the DC power port using M12 adapter:
SUMMARY STEPS
1. Ensure the O-ring is on the M12-PWR adapter.
2. Plug in DC connector into the chassis. Press M12-PWR adapter onto the chassis, and ensure that the wires
are not pinched.
3. Tighten the M12-PWR adapter captive screws into the chassis.
DETAILED STEPS
Step 1 Ensure the O-ring is on the M12-PWR adapter.
Step 2 Plug in DC connector into the chassis. Press M12-PWR adapter onto the chassis, and ensure that the wires are not pinched.
Cisco Catalyst IW9167E Heavy Duty Access Point Hardware Installation Guide
39
Installation Overview
Connecting DC Power Port Using M12 Adapter