• 8 x N-type female connectors for Wi-Fi, 1x TNC female for GNSS, multi-protocol loT radio, Aux radio,
Barometer
• Bluetooth Low Energy (BLE) radio enables IoT use cases such as location tracking and wayfinding
• Client or AP mode – Cisco URWB, WGB, or AP
• 1 x multi-Gigabit (mGig) copper Ethernet port (supporting PoE, including IEEE 802.3at/bt, Cisco UPoE,
100 Mbps/1 Gbps/2.5 Gbps/5 Gbps)
• 1 x SFP interface – supports up to 10 Gbps
For 10G SFP fiber module, Cisco PID SFP-10G-LR10-I has guaranteed
performance with IW9167EH access point.
Note
• Optional M12 adapter for network and power interfaces
• Dual power input options – PoE-in and 24 - 48VDC
• Water and dust resistance – IP 66/67
• Hardened for shock, vibration, and extreme temperatures
• Operating temperature: -40°C to 70°C without solar loading. Support cold start at -40°C and extend
working at -50°C.
Connectors and Ports
The following figures show the available ports on the AP.
Cisco Catalyst IW9167E Heavy Duty Access Point Hardware Installation Guide
2
About Cisco Catalyst IW9167E Heavy Duty Access Point
Connectors and Ports
To Next Page