EasyManuals Logo

Cisco cBR 8 Configuration Guide

Cisco cBR 8
156 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #117 background imageLoading...
Page #117 background image
Any one or several of these steps or commands may be used, in nearly any combination, to set or re-configure
SGAC on the Cisco CMTS.
Application rules for SGAC are global configurations, and downstream bandwidth resources use the same
sets of service flow rules.
Note
Procedure
PurposeCommand or Action
Enables privileged EXEC mode.enable
Step 1
Example:
Router> enable
•
Enter your password if prompted.
Enters global configuration mode.configure terminal
Example:
Router# configure terminal
Step 2
For PacketCable, this command variation maps PacketCable
service flow attributes to the specified bucket. PacketCable
cable application-type n include
packetcable { normal | priority }
Step 3
service flows are associated with PacketCable gates. The gate
can be normal or high-priority.
Example:
Router(config)# cable
application-type 5 include
packetcable priority
For PCMM, this command variation maps PCMM service
flow priority or application to the specified bucket. The PCMM
cable application-type n include
pcmm {priority gate-priority /
app-id gate-app-id }
Step 4
gates are characterized by a priority level and by an application
identifier.
Example:
Router(config)# cable
application-type 2 include pcmm
priority 7
Router(config)# cable
application-type 2 include pcmm
app-id 152
For service class parameters, this command variation applies
a service class name to the service flows, and applies
corresponding QoS parameters.
cable application-type n include
service-class service-class-name
Example:
Router(config)# cable
Step 5
DOCSIS 1.1 introduced the concept of service classes. A
service class is identified by a service class name. A service
class name is a string that the Cisco CMTS associates with a
application-type 1 include
service-class stream1
QoS parameter set One of the objectives of using a service
class is to allow the high level protocols to create service flows
with the desired QoS parameter set. Using a service class is
a convenient way to bind the application with the service
Cisco cBR Series Converged Broadband Routers Quality of Services Configuration Guide for Cisco IOS XE Fuji
16.7.x
107
Service Group Admission Control
Defining Rules for Service Flow Categorization

Table of Contents

Other manuals for Cisco cBR 8

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Cisco cBR 8 and is the answer not in the manual?

Cisco cBR 8 Specifications

General IconGeneral
BrandCisco
ModelcBR 8
CategoryNetwork Router
LanguageEnglish

Related product manuals