Dynamic bandwidth sharing cannot be disabled on the Cisco cBR router.Important
This section contains the following procedures:
Configuring DBS for a Wideband Cable Interface
Perform the following to configure the bandwidth allocation for a wideband cable interface.
Procedure
PurposeCommand or Action
Enables privileged EXEC mode.enable
Step 1
Example:
Router> enable
•
Enter your password if prompted.
Enters global configuration mode.configure terminal
Example:
Router# configure terminal
Step 2
Configures a wideband cable interface.interface wideband-cable
slot/subslot/portwideband-channel
Step 3
Example:
Router(config)# interface wideband-cable
1/0/0:0
Configures the bandwidth allocation for
the wideband channel interface.
cable rf-channel channel-list grouplist
[bandwidth-percent bw-percent ]
Example:
Router(config-if)# cable rf-channel
channel-list 10 bandwidth-percent 50
Step 4
Configuring DBS for an Integrated Cable Interface
Perform this procedure to configure the bandwidth allocation for an integrated cable interface.
Procedure
PurposeCommand or Action
Enables privileged EXEC mode.enable
Step 1
Cisco cBR Series Converged Broadband Routers Quality of Services Configuration Guide for Cisco IOS XE Fuji
16.7.x
3
Dynamic Bandwidth Sharing
Configuring DBS for a Wideband Cable Interface
To Next Page
Loading...
