Cisco FirePOWER ASA 5500 series User Manual

Contents
viii
Cisco Security Appliance Command Line Configuration Guide
OL-10088-01
CHAPTER 11 Configuring Multicast Routing 11-13
Multicast Routing Overview 11-13
Enabling Multicast Routing 11-14
Configuring IGMP Features 11-14
Disabling IGMP on an Interface 11-15
Configuring Group Membership 11-15
Configuring a Statically Joined Group 11-15
Controlling Access to Multicast Groups 11-15
Limiting the Number of IGMP States on an Interface 11-16
Modifying the Query Interval and Query Timeout 11-16
Changing the Query Response Time 11-17
Changing the IGMP Version 11-17
Configuring Stub Multicast Routing 11-17
Configuring a Static Multicast Route 11-17
Configuring PIM Features 11-18
Disabling PIM on an Interface 11-18
Configuring a Static Rendezvous Point Address 11-19
Configuring the Designated Router Priority 11-19
Filtering PIM Register Messages 11-19
Configuring PIM Message Intervals 11-19
Configuring a Multicast Boundary 11-20
Filtering PIM Neighbors 11-20
Supporting Mixed Bidirctional/Sparse-Mode PIM Networks 11-21
For More Information about Multicast Routing 11-21
CHAPTER 12 Configuring IPv6 12-1
IPv6-enabled Commands 12-1
Configuring IPv6 12-2
Configuring IPv6 on an Interface 12-3
Configuring a Dual IP Stack on an Interface 12-4
Enforcing the Use of Modified EUI-64 Interface IDs in IPv6 Addresses 12-4
Configuring IPv6 Duplicate Address Detection 12-4
Configuring IPv6 Default and Static Routes 12-5
Configuring IPv6 Access Lists 12-6
Configuring IPv6 Neighbor Discovery 12-7
Configuring Neighbor Solicitation Messages 12-7
Configuring Router Advertisement Messages 12-9
Configuring a Static IPv6 Neighbor 12-11

Cisco FirePOWER ASA 5500 series Specifications

General

Brand	Cisco
Model	FirePOWER ASA 5500 series
Category	Firewall
Language	English