Cisco NCS 1002 System Setup And Software Installation Guide

sysadmin-vm:0_RP0# show platform
Wed Feb 28 03:31:53.672 UTC
Location Card Type HW State SW State Config State
----------------------------------------------------------------------------
0/0 NCS1002-K9 OPERATIONAL N/A NSHUT
0/RP0 NCS1K-CNTLR OPERATIONAL OPERATIONAL NSHUT
0/FT0 NCS1K-FTA OPERATIONAL N/A NSHUT
0/FT1 NCS1K-FTA OPERATIONAL N/A NSHUT
0/FT2 NCS1K-FTA OPERATIONAL N/A NSHUT
Verify that all the modules of the NCS 1002 are displayed in the result. The software state and the hardware
state must be in the OPERATIONAL state. The various hardware and software states are:
Hardware states:
• OPERATIONAL—Node is operating normally and is fully functional.
• POWERED_ON—Power is on and the node is booting up.
• FAILED—Node is powered on but has experienced some internal failure.
• PRESENT—Node is in the shutdown state.
• OFFLINE—User has changed the node state to OFFLINE. The node is accessible for diagnostics.
Software states:
• OPERATIONAL—Software is operating normally and is fully functional.
• DIAG_MODE—User has changed the card state to OFFLINE for diagnosis.
• SW_INACTIVE—Software is not completely operational.
• FAILED—Software is operational but the card has experienced some internal failure.
Step 4 show platform detail
Displays the hardware and software states, and other details of the node.
Example:
sysadmin-vm:0_RP0# show platform detail
Wed Feb 28 03:33:14.557 UTC
Platform Information for 0/0
PID : NCS1002-K9
Description : "Network Convergence System 1002 20 QSFP28/QSFP+ slots"
VID/SN : V01
HW Oper State : OPERATIONAL
SW Oper State : N/A
Configuration : "NSHUT RST"
HW Version : 0.1
Last Event : HW_EVENT_OK
Last Event Reason : "HW Event OK"
Platform Information for 0/RP0
PID : NCS1K-CNTLR
Description : "Network Convergence System 1000 Controller"
VID/SN : V03
HW Oper State : OPERATIONAL
SW Oper State : OPERATIONAL
Configuration : "NSHUT RST"
HW Version : 0.1
Last Event : HW_EVENT_OK
System Setup and Software Installation Guide for Cisco NCS 1002
22
Perform Preliminary Checks
Verify Node Status

Cisco NCS 1002 Specifications

General

Brand	Cisco
Model	NCS 1002
Category	Network Hardware
Language	English