Cisco NCS 1002 System Setup And Software Installation Guide

0/PM0 NCS1K-2KW-AC 0.0 PO-PriMCU CURRENT 4.00 4.00
0/PM1 NCS1K-2KW-AC 0.0 PO-PriMCU CURRENT 4.00 4.00
Displays the firmware information of various hardware components of the NCS 1002 in the Cisco IOS XR
EXEC mode.
In the above output, some of the significant fields are:
• FPD Device—Name of the hardware component such as FPD, CFP, and so on.
• ATR—Attribute of the hardware component. Some of the attributes are:
• B—Backup Image
• S—Secure Image
• P—Protected Image
• Status— Upgrade status of the firmware. The different states are:
• CURRENT—The firmware version is the latest version.
• READY—The firmware of the FPD is ready for an upgrade.
• NOT READY—The firmware of the FPD is not ready for an upgrade.
• NEED UPGD—A newer firmware version is available in the installed image. It is recommended
that an upgrade be performed.
• RLOAD REQ—The upgrade has been completed, and the ISO image requires a reload.
• UPGD DONE—The firmware upgrade is successful.
• UPGD FAIL— The firmware upgrade has failed.
• BACK IMG—The firmware is corrupted. Reinstall the firmware.
• UPGD SKIP—The upgrade has been skipped because the installed firmware version is higher than
the one available in the image.
• Running—Current version of the firmware running on the FPD.
Step 2 show hw-module slice slice_number
Displays the slice and Datapath FPGA (DP-FPGA) information of the NCS 1002.
Example:
RP/0/RP0/CPU0:ios# show hw-module slice 0
Wed Feb 28 04:01:45.828 UTC
Slice ID: 0
Status: Provisioned
Client Bitrate: 10
Trunk Bitrate: 100
DP FPGA FW Type: XMG1
DP FPGA FW Version: 01.01
HW Status: CURRENT
Encryption Supported: FALSE
LLDP Drop Enabled: FALSE
Client Port - Trunk Port CoherentDSP0/0/0/5 CoherentDSP0/0/0/6
Traffic Split Percentage
System Setup and Software Installation Guide for Cisco NCS 1002
25
Perform Preliminary Checks
Verify Firmware Version

Cisco NCS 1002 Specifications

General

Brand	Cisco
Model	NCS 1002
Category	Network Hardware
Language	English