Cisco ONS 15454 SDH - Set Node Default BBE or SES Card Thresholds

1-98
Cisco ONS 15454 SDH Troubleshooting Guide, R5.0
July 2005
Chapter 1 General Troubleshooting
1.6.5 Performance Monitoring Counters and Threshold Crossing Alerts
Figure 1-41 Performance Monitoring Points on ONS DWDM
TCAs are used to monitor performance through the management interface by indicating whether preset
thresholds have been crossed, or whether a transmission (such as a laser transmission) is degraded. TCAs
are not associated with severity levels. They are usually associated with rate, counter, and percentage
parameters that are available at transponder monitoring points. Chapter 4, “Performance Monitoring,”
contains more information about these alerts. Select and complete the provisioning procedure below
according to your network parameters.
Complete the following procedure to provision default node ODUk BBE and SES PM thresholds for
TXP cards.
Set Node Default BBE or SES Card Thresholds
Step 1 In node view, click the Provisioning > Defaults tabs (Figure 1-42).