Cisco ONS 15454 Series Reference Manual

16 N.C. 42 COM_10
17 COM_11 43 N.C.
18 NO_11 44 NO_12
19 N.C. 45 COM_12
20 COM_13 46 N.C.
21 NO_13 47 NO_14
22 N.C. 48 COM_14
23 COM_15 49 N.C.
24 NO_15 50 N.C.
25 N.C. 51 GND1
26 NO_0 52 GND2
Filler Card
Filler cards are designed to occupy empty multiservice and AIC-I slots in the Cisco ONS 15454 (Slots 1-6, 9,
and 12 - 17). The filler card cannot operate in the XC slots (Slots 8 and 10) or TCC slots (7 and 11). When
installed, the filler card aids in maintaining proper air flow and EMI requirements.
Note: There are two types of filler cards, a detectable version (Cisco P/N 15454-FILLER) and a
non-detectable version (Cisco P/N 15454-BLANK). The detectable card has the label FILLER on the
faceplate. The non-detectable card has no faceplate label. In Software Release 6.0 and greater, the former
card is detectable through CTC when installed in the ONS 15454 shelf.
Figure 1-36 shows the faceplate of the detectable filler card. The filler cards have no card-level LED
indicators.
Figure 1-36: Detectable Filler Card Faceplate
ONS_15454_Reference_Manual_R8.5.x_--_Shelf_and_Backplane_Hardware
Table 1-24: Pin Association for Alarm Output Pins 47

Cisco ONS 15454 Series Specifications

General

Supported Interfaces	Ethernet
Management	Cisco Transport Controller (CTC), TL1, SNMP
Power Supply	-48 VDC or AC (depending on power supply module)
Operating Temperature	0 to 50°C (32 to 122°F) - varies by module
Storage Temperature	-40°C to 70°C (-40 to 158°F)
Relative Humidity	5 to 95%, noncondensing
Supported Protocols	SONET/SDH, Ethernet, OTN
Platform Type	Multi-service transport platform