A-6
Cisco ONS 15454 SONET/SDH ML-Series Multilayer Ethernet Card Software Feature and Configuration Guide, R4.0
78-15224-02
Appendix A Command Reference
[no] pos trigger delay <time>
[no] pos trigger delay <time>
Use this command to specify which conditions cause the associated POS link state to go change. The
conditions specified in the pos trigger defects command are soaked/cleared using this delay. Use the
no form of the command to use the default value.
Defaults The default value is 200 milliseconds.
Command Modes Interface configuration mode (POS only)
Usage Guidelines This value is normally configured to match the setting on the peer Path Terminating Equipment (PTE).
The time granularity for this command is 50 milliseconds.
Examples
Gateway(config)#int pos0
Gateway(config-if)#pos trigger delay 500
Related Commands pos trigger defects
Parameter Description
time delay time in milliseconds, 200 to 2000
To Next Page
Loading...
