A-7
Cisco ONS 15454 SONET/SDH ML-Series Multilayer Ethernet Card Software Feature and Configuration Guide, R4.0
78-15224-02
Appendix A Command Reference
[no] pos scramble-spe
[no] pos scramble-spe
Use this command to enable scrambling.
Syntax Description This command has no arguments or keywords.
Defaults The default value depends on the encapsulation.
Command Modes Interface configuration mode (POS only)
Usage Guidelines This value is normally configured to match the setting on the peer Path Terminating Equipment (PTE).
This command may change the pos flag c2 configuration.
Examples
Gateway(config)#int pos0
Gateway(config-if)#pos scramble-spe
Related Commands pos flag c2
encap scrambling
LEX pos scramble-spe
PPP/HDLC no pos scramble-spe
To Next Page
Loading...
