Cisco ONS 15454 - Page 204

A-8
Cisco ONS 15454 SONET/SDH ML-Series Multilayer Ethernet Card Software Feature and Configuration Guide, R4.0
78-15224-02
Appendix A Command Reference
show controllers pos <interface-number> [details]
show controllers pos <interface-number> [details]
Use this command to display the status of the POS controller. Use the details argument to obtain certain
additional information as described below.
Defaults N/A
Command Modes Privileged EXEC
Usage Guidelines This command may be used to help diagnose and isolate POS or SONET problems.
Examples
Gateway#show controllers pos0 details
Interface POS0
Hardware is Packet/Ethernet over Sonet
PATH
PAIS = 0 PLOP = 0 PRDI = 0 PTIM = 0
PPLM = 3 PUNEQ = 0 PPDI = 0
BER_SF_B3 = 0 BER_SD_B3 = 0 BIP(B3) = 0 REI = 15
NEWPTR = 1 PSE = 0 NSE = 0
Active Alarms : None
Demoted Alarms: None
Active Defects: None
Alarms reportable to CLI: PAIS PRDI PLOP PUNEQ PPLM PTIM PPDI BER_SF_B3 BER_SD_B3
Link state change defects: PAIS PLOP PRDI BER_SF_B3
Link state change time : 500 (msec)
DOS FPGA channel number: 0
Starting STS (0 based) : 0
Circuit size : STS-3c
RDI Mode : 1 bit
C2 (tx / rx) : 0x16 / 0x16
Framing : SONET
Path Trace
Mode : off
Buffer : Unstable
Remote hostname :
Remote interface:
Remote IP addr :
B3 BER thresholds:
SFBER = 1e-5, SDBER = 1e-7
Xmt Str:
00 00 00 00 00 00 00 00 00 00 00 00 00 00 00 00 ................
00 00 00 00 00 00 00 00 00 00 00 00 00 00 00 00 ................
00 00 00 00 00 00 00 00 00 00 00 00 00 00 00 00 ................
00 00 00 00 00 00 00 00 00 00 00 00 00 00 00 00 ................
Exp Str:
Parameter Description
interface-number Number of the POS interface <0-1>