Cisco ONS 15454 - Page 208

A-12
Cisco ONS 15454 SONET/SDH ML-Series Multilayer Ethernet Card Software Feature and Configuration Guide, R4.0
78-15224-02
Appendix A Command Reference
show ons alarm
show ons alarm
Use this command to display all the active alarms on the card.
Syntax Description This command has no arguments or keywords.
Defaults N/A
Command Modes Privileged EXEC
Usage Guidelines This command may be used to help diagnose and isolate card problems.
Examples
Gateway# show ons alarm
Equipment
Active Alarms: None
Port Alarms
POS0 Active: TPTFAIL
POS1 Active: TPTFAIL
GigabitEthernet0 Active: None
GigabitEthernet1 Active: None
POS0
Active Alarms : None
Demoted Alarms: None
POS1
Interface not provisioned
Related Commands show controller pos
show ons alarm defects
show ons alarm failures