Cisco SCE 8000 User Manual

B-3
Cisco SCE8000 GBE Installation and Configuration Guide
Appendix B CLI Commands to Verify a Successful Installation
CLI Command Output Samples
Complete command sequence for a fully-populated Cisco SCE 8000 10 GBE platform using both the SM and the QM
SCE8000> enable 5
Password:<cisco>
SCE8000> show version
SCE8000>
show inventory
SCE8000> show interface TenGigabitEthernet 3/0/0
SCE8000> show interface TenGigabitEthernet 3/1/0
SCE8000> show interface TenGigabitEthernet 3/2/0
SCE8000> show interface TenGigabitEthernet 3/3/0
SCE8000> show system operation-status
SCE8000> show interface linecard 0
SCE8000> show interface linecard 0 connection-mode
SCE8000> show interface linecard 0 link mode
SCE8000> show interface linecard 0 external-bypass
SCE8000> show rdr-formatter
SCE8000> show interface linecard 0 subscriber sm-connection-failure
SCE8000> show ip rpc-adapter sessions
CLI Command Output Samples
The text in bold in the following output samples indicates the lines you should check when doing a
post-installation check. For some commands, the output is short and the entire output is relevant. In these
cases, nothing is in bold.
RDR formatter show RDR-formatter Verify the following:
• RDR formatter has established a
connection with the configured
destinations.
• Redundancy status is configured
correctly in case of more then one
destination.
Connection to Subscriber Manager show interface linecard subscriber
sm-connection-failure
If using SM, verify that the connection
with the SM is established.
Connection to Quota Manager show ip rpc-adapter sessions If using QM, verify that the connection
with the QM is established.
To check this Use this command Comments

Cisco SCE 8000 Specifications

General

Brand	Cisco
Model	SCE 8000
Category	Switch
Language	English