Cisco SCE 8000 User Manual

C-8
Cisco SCE8000 GBE Installation and Configuration Guide
Appendix C Cisco Service Control Engine System Log Messages
Informational Messages, Severity Level 6
Error Message %LOCAL7-6-ENABLED_CONF_CHANGED: "Attack-filter configuration was <%s>
for some (or all) attack types."
Explanation
This message is displayed to indicate the status of the attack filter configuration.
Recommended Action None.
Error Message %LOCAL7-6-HOST_NAME_CHANGED: "System hostname changed to hostname.
Explanation
This message is displayed to indicate that the system hostname is changed to the
configured host name.
In this message, hostname is the new host name.
Recommended Action None.
Error Message %LOCAL7-6-FLASH_TO_DEFAULT_CALLED: CPU#000 'Reset to Default' called."
Explanation
This message is displayed to indicate that the system has started resetting the Cisco SCE
configurations to factory default configurations.
Recommended Action None.
Error Message %LOCAL7-6-FLASH_TO_DEFAULT_FINISHED: "'Reset to Default' finished."
Explanation This message is displayed to indicate that the system has completed resetting the Cisco
SCE configurations to factory default configurations.
Recommended Action None.
Error Message %LOCAL7-6-SOFT_RESET_AND_REFRESH_OK_USER: "Linecard in slot
slot-number was soft-reset and refreshed with all data."
Explanation
This message is displayed to indicate that the linecard in the slot has been soft reset and
refreshed with all the data. (The soft reset refreshes the linecard to the state it was in before the
reset).
Recommended Action None.
Error Message %LOCAL7-6-REBOOTCC_CALLED:"Rebooting the box per user request."
Explanation
This message is displayed while rebooting the Cisco SCE 8000 platform on a user’s
request.
Recommended Action None.

Cisco SCE 8000 Specifications

General

Brand	Cisco
Model	SCE 8000
Category	Switch
Language	English